Dell Active Fabric Manager Guide de l'utilisateur télécharger pdf (Page 98)

Figure 41. VLT VLAN Configuration Without Using the Enable Layer 3 Protocol in Access Switches Option

The following screen shot displays a VLT VLAN Configuration screen using the Enable Layer 3 protocol in Access

Switches option. To have the topology for a Layer 3 with Resiliency (Routed VLT) support both access and aggregation

devices, select the Enable Layer 3 protocol in Access Switches option. When you use this option, provide the network IP

address range using the Add VLAN Range link. The IP addresses are assigned to all the access and aggregation

switches.

Figure 42. Layer 3 with Resiliency Using the Enable Layer 3 Protocol in Access Switches Option

The following screen shot displays the results after checking the Enable Layer Protocol in Access Switches option and

adding VLANs for a Layer 3 with Resiliency (Routed VLT) fabric.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 178 179

Pas de commentaire

Dell Active Fabric Manager Guide de l'utilisateur Page 98