Dell Server Console Switch Guide de l'utilisateur télécharger pdf (Page 22)

22 Installation

www.dell.com | support.dell.com

Cascading with Legacy Switches

To add a legacy switch (optional):

1 Mount the switch into your rack. Locate a CAT 5 cable to connect your Remote Console

Switch unit to the legacy switch (Figure 2-7).

2 Attach one end of the CAT 5 cabling to the ARI port on the Console Switch.

3 Connect the other end of the CAT 5 cable to a Dell SIP or Avocent AVRIQ.

4 Connect the SIP or AVRIQ to your legacy switch according to the switch manufacturer's

recommendations.

5 Repeat steps 1-3 for all the legacy switches you wish to attach to your Remote Console

Switch system.

NOTE: The Remote Console Switch supports only 1 switch per ARI port. You cannot cascade another

switch under this first switch.

NOTE: When cascading with a Remote Console Switch, an 8-port or 16-port analog console switch is

not supported as the primary unit. The Remote Console Switch must be the primary unit.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Pas de commentaire

Dell Server Console Switch Guide de l'utilisateur Page 22