Dell 3100 Spécifications télécharger pdf (Page 114)

100

101

Cantilever Preparation

Silicon Nitride Cantilever Substrates

94 Dimension 3100 Manual Rev. D

5. Place the strip down on a white piece of paper to inspect it under the microscope.

6. Handling the strip by its ends, place it on a glass slide (taped down to the edge of a table)

with the substrate or spacer piece to be removed hanging over the edge (see Figure 6.2b).

The saw cut should be approximately on the edge of the slide.

7. While holding down the next substrate on the strip with the wooden end of a cotton swab,

grip the overhanging piece with a pair of wide tweezers and rotate downward until the

cantilever substrate breaks off.

8. Repeat this process until as many cantilever substrates as required are removed.

CAUTION: Be careful to avoid pushing strips together as the cantilevers are

between the strips. All cantilevers on one side of both strips could

break off if the strips are inadvertently pushed together.

CAUTION: Verify that the cantilevers are on the top side of the strip. The

cantilevers are on the same side as the reinforcing ring, while the

saw-cuts are on the opposite side from the cantilevers. Between

each one on the down side of the strip there should be a saw-cut

almost through the Pyrex.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 375 376

Commentaires sur ces manuels

Pas de commentaire

Dell 3100 Spécifications Page 114

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Dell 3100