Dell Networking S5000 Manuel d'installation Page 19
- Page / 50
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
5
Site Preparations
The S5000 is suitable for installation as part of a Common Bond Network (CBN). It can be installed in:
• network telecommunication facilities
• data centers
• other locations where the National Electric Code (NEC) applies
This chapter contains the following sections:
• Site Selection
• Cabinet Placement
• Storing Components
Site Selection
Dell Networking equipment is intended for installation in restricted access areas. A restricted access area can only be
accessed by service personnel by using a special tool, lock, key or other means of security and access is controlled by
the authority responsible for the location.
Ensure that the area where you install your S5000 system meets the following safety requirements:
• Near an adequate power source. Connect the system to the appropriate branch circuit protection as defined by
your local electrical codes.
• Environmental temperature between 32° to 104°F (0° to 40°C).
• Relative humidity that does not exceed 85 percent noncondensing.
• In a dry, clean, well-ventilated and temperature-controlled room, away from heat sources such as hot air vents
or direct sunlight.
• Away from sources of severe electromagnetic noise.
• Positioned in a rack or cabinet, or on a desktop with adequate space in the front, rear, and sides of the S5000 for
proper ventilation and access.
Cabinet Placement
Install the S5000 only in indoor cabinets designed for use in a controlled environment as described in Site Selection.
The cabinet must meet the following criteria:
• Minimum cabinet size and airflow are according to the Electronic Industries Alliance (EIA) standard.
19
- Dell Networking S5000 1
- Installation Guide 1
- Notes, Cautions, and Warnings 2
- Contents 3
- About this Guide 5
- Introduction 7
- Unpacking the Switch 9
- Hardware Overview 11
- Utility Panel 12
- Port Numbering Convention 13
- System Status 13
- Figure 7. Module LEDs 15
- Figure 8. QSFP+ Port LEDs 17
- Site Preparations 19
- Storing Components 20
- Installation 21
- Environmental Parameters 22
- Rack Grounding 24
- Installing an Ethernet Module 25
- Replacing an Ethernet Module 26
- S5000 Switch 28
- Installing an AC Power Supply 29
- Installing a DC Power Supply 32
- Securing Power Cables 35
- Installing a Fan Module 37
- Replacing a Fan Module 37
- Important Points to Remember 38
- Figure 24. Stacking Topology 39
- Connecting Two S5000 Systems 40
- Hot-Swapping Units in a Stack 42
- Technical Specifications 43
- Agency Compliance 45
- European Community Contact 46
- Technical Support 49
- Contacting Technical Support 50
Electrolux Air-O-Convect AOS102GCD1 manuals
Owner’s manuals and user’s guides for Convection ovens Electrolux Air-O-Convect AOS102GCD1.
We providing 1 pdf manuals Electrolux Air-O-Convect AOS102GCD1 for download free by document types: User Manual
Commentaires sur ces manuels