Dell T420 Manuel du propriétaire Page 129

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 173
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 128
4
Converting The System From Tower Mode To
Rack Mode
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
CAUTION: Do not attempt to convert your system into a rack unless authorized by Dell. Only customers certified by
Dell for tower to rack conversion can convert a tower system into a rack system.
Safety Instructions
NOTE: For specific caution statements and procedures, see the rack installation documentation for your system at
support.dell.com/manuals. For complete safety and regulatory information, see the safety instructions that shipped
with your system.
Observe the following precautions for stability and safety of the system in rack mode:
Before installing your equipment in a rack, install the front and side rack stabilizers. Failure to install stabilizers
can allow the rack to tip over.
Always load from the bottom up, and load the heaviest items first.
Do not overload the AC power supply branch circuit that provides power to the rack.
Do not stand or step on any components in the rack.
Preparing A System For Conversion From Tower Mode To Rack
Mode
You require the tower to rack conversion kit, which contains the following items:
Rack ears (left and right) with three screws each
VGA module
Control panel for rack mode
LCD panel
Rack slide cover
Mylar cover
If applicable, a pair of rails
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2. If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable
surface.
129
Vue de la page 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 172 173

Commentaires sur ces manuels

Pas de commentaire