Dell LATITUDE D400 Manuel d'utilisateur télécharger pdf (Page 10)

Back to Contents Page



Display

Removing the Display Assembly

Replacing the Display Latch



Removing the Display Assembly



1. Follow the instructions in "Preparing to Work Inside the Computer" to remove the battery and prepare the computer for work.

2. Remove the battery.

3. Remove the hard drive.

4. Remove the center control cover.

5. Remove the two M2.5 x 6-mm screws next to each hinge.



6. Remove the two M2.5 x 6-mm screws from the display-feed flex cable hold-down board.

7. Use the pull-tab to disconnect the display-feed flex cable from its connector on the system board.

8. Move the display assembly to an upright position and pull it up out of the computer.



Replacing the Display Latch



CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

display-feed flex cable



M2.5 x 6-mm screws (6)

4911U

display-feed flex cable hold-down board



pull-tab



CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Commentaires sur ces manuels

Pas de commentaire

Dell LATITUDE D400 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Dell LATITUDE D400