Dell PowerEdge 2600 Manuel d'utilisateur télécharger pdf (Page 16)

Installing the Cover, Feet, and Bezel

1 Lay the system on its left side.

2 Replaee the system eover.

3 Position a metal foot over the hole in eaeh eorner and seeure the foot with a

6-52 X 0.25-ineh hex-head Phillips serew.

* Replaee the bezel:

a Align the two thumbserew with the mounting holes on the front of the system

(see Figure 1-4).

b Tighten the thumbserews to seeure the bezel (see Figure 1-4).

c Swing the bezel elosed until it snaps into plaee.

d Using the system key, loek the bezel.

Removing the Slide Assemblies

At the front of the гаек eabinet, loeate the blue release push-button on one of the slide

assembly’s mounting-braeket flanges (see Figure 1-7).

From the front of the raek eabinet, press in on the blue release push button, lift up,

and push the slide assembly baek approximately one ineh away from the front vertieal

rail until the mounting-braeket flange and its mounting hooks disengage from the

square holes in the front vertieal rail (see Figure 1-7).

Repeat step 2 at the baek of the eabinet for this slide assembly

Repeat steps 1 through 3 for the remaining slide assembly on the other side of the

raek.

Plaee the eable-management arm, the eable tray, the slide assemblies, and all fastener

hardware in a box. Label the box as a raek installation kit for the system model you

removed from the raek.

1-12 I Rack-to-Tower Conversion Guide

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 89 90

Pas de commentaire

Dell PowerEdge 2600 Manuel d'utilisateur Page 16