Dell PowerEdge 2600 Manuel d'utilisateur télécharger pdf (Page 6)

• System rack kits are intended to be installed in a rack by trained service technicians. If

you install the kit in any other rack, be sure that the rack meets the specifications of a

Dell rack.

/K CAUTION: Do not move racks by yourself. Due to the height and weight of the

rack, a minimum of two people should accomplish this task.

• Before working on the rack, make sure that the stabilizers are secured to the rack,

extended to the floor, and that the full weight of the rack rests on the floor. Install

front and side stabilizers on a single rack or front stabilizers for joined multiple racks

before working on the rack.

• Always load the rack from the bottom up, and load the heaviest item in the rack first.

• Make sure that the rack is level and stable before extending a component from the

rack.

• Use caution when pressing the component rail release latches and sliding a component

into or out of a rack; the slide rails can pinch your fingers.

• After a component is inserted into the rack, carefully extend the rail into a locking

position, and then slide the component into the rack.

• Do not overload the AC supply branch circuit that provides power to the rack. The

total rack load should not exceed 80 percent of the branch circuit rating.

• Ensure that proper airflow is provided to components in the rack.

• Do not step on or stand on any component when servicing other components in a rack.

Rack-to-Tower Kit Contents

The rack-to-tower kit includes the following items (see Figure 1-1):

• One tower bezel and system badge assembly, complete with keylock, and keys

• One tower front panel

• One tower left-side trim panel

• Four metal feet

• Four 6-52 x 0.25-inch hex-head Phillips screws

• Sixteen 6-52 x 0.512-inch black flat-head Torx screws

1-2 I Rack-to-Tower Conversion Guide

1 2 3 4 5 6 7 8 9 10 11 ... 89 90

Pas de commentaire

Dell PowerEdge 2600 Manuel d'utilisateur Page 6