Dell PowerVault DR6000 Manuel d'utilisateur télécharger pdf (Page 41)

Hard Drives

All hard drives connect to the system board through the hard-drive backplane. Hard drives are supplied in

hot-swappable hard-drive carriers that fit in the hard-drive slots.

CAUTION: Before attempting to remove or install a hard drive while the system is running, see the

documentation for the storage controller card to ensure that the host adapter is configured

correctly to support hot-swap hard drive removal and insertion.

CAUTION: Do not turn off or reboot your system while the hard drive is being formatted. Doing

so can cause a hard drive failure.

NOTE: Use only hard drives that have been tested and approved for use with the hard-drive

backplane.

When you format a hard drive, allow enough time for the formatting to be completed. Be aware that

high-capacity hard drives can take a number of hours to format.

Removing A 2.5 Inch Hard-Drive Blank (Back)

CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks

installed.

Pull the hard-drive blank out until it is free of the hard-drive slot.

Figure 14. Removing and Installing a 2.5 Inch Hard-Drive Blank (Back)

1. hard-drive blank (back)

Installing A 2.5 Inch Hard-Drive Blank (Back)

Insert the hard-drive blank into the hard-drive slot until it clicks into place.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 123 124

Pas de commentaire

Dell PowerVault DR6000 Manuel d'utilisateur Page 41