Dell PowerVault DR6000 Manuel d'utilisateur télécharger pdf (Page 79)

6. Reconnect all the cables to the backplane.

7. Install both the hard drives in their original location.

8. Close the system.

9. Reconnect the system to its electrical outlet and turn the system on, including any attached

peripherals.

I/O Panel

Removing The I/O Panel

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that came with the product.

1. If installed, remove the front bezel.

2. Turn off the system, including any attached peripherals, and disconnect the system from the

electrical outlet and peripherals.

3. Open the system.

CAUTION: To prevent damage to the I/O cable, you must release the locking tab before

removing or installing the I/O cable from the connector on the hard-drive backplane.

4. Rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.

5. Disconnect the I/O cable from the backplane.

6. Remove the three Torx screws securing the I/O panel to the chassis.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 123 124

Pas de commentaire

Dell PowerVault DR6000 Manuel d'utilisateur Page 79