Dell PowerVault DR6000 Manuel d'utilisateur télécharger pdf (Page 71)

4. Connect the power cable to the power supply and plug the cable into a power outlet.

CAUTION: When connecting the power cable, secure the cable with the strap.

NOTE: When installing, hot-swapping, or hot-adding a new power supply, allow several

seconds for the system to recognize the power supply and determine its status. The power-

supply status indicator turns green to signify that the power supply is functioning properly.

Removing The Power Supply Blank

CAUTION: To ensure proper system cooling, the power supply blank must be installed in the

second power supply bay in a non-redundant configuration. Remove the power supply blank

only if you are installing a second power supply.

If you are installing a second power supply, remove the power supply blank in the bay by pulling

outward on the blank.

Figure 38. Removing and Installing the Power Supply Blank

1. power supply blank

Installing The Power Supply Blank

NOTE: Install the power supply blank only in the second power supply bay.

To install the power supply blank, align the blank with the power supply bay and insert it into the chassis

until it clicks into place.

System Battery

Replacing The System Battery

WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the

battery only with the same or equivalent type recommended by the manufacturer. See your

safety information for additional information.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 123 124

Pas de commentaire

Dell PowerVault DR6000 Manuel d'utilisateur Page 71