Dell Dimension 8400 Manuel d'utilisateur télécharger pdf (Page 101)

Removing and Installing Parts 101

Installing a CD/DVD Drive

If you are installing a new drive, unpack the drive and prepare it for installation.

Check the documentation that accompanied the drive to verify that the drive is configured

for your computer. If you are installing an IDE drive, configure the drive for the cable select

setting.

Connect the new drive to the set of rails that are attached to the inside of the cover. If a set of

rails is not attached inside the cover, contact Dell (see page 123).

If you are installing a replacement drive and the new drive does not have the bracket rails

attached, remove the rails from the old drive by removing the two screws that secure each rail

to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with

the screw holes on the bracket rails and then inserting and tightening all four screws (two

screws on each rail).

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 145 146

Pas de commentaire

Dell Dimension 8400 Manuel d'utilisateur Page 101