Dell OptiPlex 7010 (Mid 2012) Manuel d'utilisateur télécharger pdf (Page 39)

Table 3. System Configuration

Option Description

Integrated NIC Allows you to enable or disable the integrated network card. You can set the

integrated NIC to:

• Disabled

• Enabled

• Enabled w/PXE

• Enabled w/ImageServer

NOTE: Depending on the computer and its installed devices, the items listed in

this section may or may not appear.

Serial Port Allows you to define the serial port settings. You can set the serial port to:

• Disabled

• COM1

• COM2

• COM3

• COM4

NOTE: The operating system may allocate resources even though the setting is

disabled.

SATA Operation Allows you to configure the operating mode of the integrated hard drive controller.

• Disabled - The SATA controllers are hidden.

• ATA - SATA is configured for ATA mode.

• AHCI - SATA is configured for AHCI mode.

• RAID ON - SATA is configured to support RAID mode.

Drives Allows you to enable or disable the various on-board drives:

• SATA-0

• SATA-1

• SATA-2

• SATA-3

SMART Reporting This field controls if the hard drive errors for the integrated drives are reported during

system startup. This technology is part of the SMART (Self Monitoring Analysis and

Reporting Technology) specification.

• Enable SMART Reporting - This option is disabled by default.

USB Configuration This field configures the integrated USB controller. If

Boot Support

is enabled, the

system is allowed to boot any type of USB mass storage devices (HDD, memory key,

floppy).

If USB port is enabled, device attached to this port is enabled and available for

operation system.

If USB port is disabled, the operation system cannot see any device attached to this

port.

The options for USB configuration differ based on the form factors:

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 61 62

Pas de commentaire

Dell OptiPlex 7010 (Mid 2012) Manuel d'utilisateur Page 39