Dell XPS 700 Jet Black Manuel d'utilisateur télécharger pdf (Page 12)

System Messages

3-1-3

Master interrupt mask register failure

3-1-4

Slave interrupt mask register failure

3-2-2

Interrupt vector loading failure

3-2-4

Keyboard Controller Test failure

3-3-1

NVRAM power loss

3-3-2

NVRAM configuration

3-4-1

Screen initialization failure

3-4-2

Screen retrace failure

4-2-1

No time tick

4-2-2

Shutdown failure

4-2-3

Gate A20 failure

4-2-4

Unexpected interrupt in protected mode

4-3-3

Timer-chip counter 2 failure

4-3-4

Time-of-day clock stopped

4-4-1

Serial or parallel port test failure

4-4-4

Cache test failure

NOTE: If the message you received is not listed in the table, see the documentation for either the operating system or the program that was running

when the message appeared.



Message



Possible Cause



Corrective Action

8042 Gate-A20

error

The keyboard controller

failed its test.

If you receive this message after you make

changes in the system setup program,

enter the system setup program and

restore the original value(s).

Address Line

Short!

An error in the address

decoding circuitry in the

memory has occurred.

Reseat the memory modules (see Memory).

C: Drive Error

C: Drive

Failure

The hard drive is not

working or is not configured

correctly.

Ensure that the hard drive is installed

correctly in the computer (see Hard Drive)

and defined correctly in the system setup

program (see System Setup).

Cache Memory

Bad, Do Not

Enable Cache

The cache memory is not

operating.

See "Contacting Dell" in your Owner's

Manual for instructions on obtaining

technical assistance.

CH-2 Timer

Error

An error is occurring on the

timer on the system board.

See "Contacting Dell" in your Owner's

Manual for instructions on obtaining

technical assistance.

CMOS Battery

State Low

CMOS Checksum

Failure

CMOS System

Options Not Set

CMOS Display

Type Mismatch

CMOS Memory

Size Mismatch

CMOS Time and

Date Not Set

The system configuration

information in the system

setup program is incorrect

or the battery charge may

be low.

Enter the system setup program (see

Entering System Setup), verify the system

configuration, and then restart the

computer.

Diskette Boot

Failure

Drive A or B is present but

has failed the BIOS POST.

Ensure that the drive is installed correctly

in the computer (see Drives) and defined

correctly in the system setup program (see

System Setup). Check the interface cable at

both ends.

DMA Error

DMA 1 Error

DMA 2 Error

Error in the DMA controller

on the system board.

The keyboard or system board may need to

be replaced.

FDD Controller

Failure

The BIOS cannot

communicate with the floppy

drive or hard drive

Ensure that the floppy drive or the hard

drive is installed correctly in the computer

(see Drives) and defined correctly in the

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 125 126

Commentaires sur ces manuels

Pas de commentaire

Dell XPS 700 Jet Black Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Dell XPS 700 Jet Black