Dell XPS 700 Jet Black Manuel d'utilisateur télécharger pdf (Page 35)



5. Ensure that all connectors are properly cabled and firmly seated.



6. Replace the computer cover (see Replacing the Computer Cover).



7. Connect your computer and devices to electrical outlets, and then turn them on.



Installing a Hard Drive



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Remove the existing hard drive, if applicable (see Removing a Hard Drive).



4. Prepare the new hard drive for installation and check the documentation for the hard drive to verify that the drive is configured for your computer.



5. Verify that the hard-drive bay is empty and unobstructed.



blue tabs (2)

hard drive

hard-drive bay

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTE: If a hard-drive bracket is installed inside of the hard-drive bay, remove the bracket before you install the new hard drive.

NOTE: If hard drive you are installing does not have the hard drive bracket attached, use your original hard drive bracket; snap the bracket onto

the new drive.

hard drive

hard-drive bracket

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 125 126

Commentaires sur ces manuels

Pas de commentaire

Dell XPS 700 Jet Black Manuel d'utilisateur Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Dell XPS 700 Jet Black