Dell D630 - LATITUDE ATG NOTEBOOK Guide de dépannage télécharger pdf (Page 32)

Back to Contents Page

 Palm Rest

Dell™Latitude™D630ServiceManual



1. Follow the instructions in Before You Begin.



2. Remove any installed media bay device (see Media Bay Devices).



3. Remove the hinge cover (see Hinge Cover).



4. Remove the keyboard (see Removing the Keyboard).



5. Remove the display assembly (see Display Assembly).



6. Disconnect the coin-cell battery from the system board (see Coin-Cell Battery).



7. Remove the three M2.5 x 8-mm screws labeled "P" from the top of the palm rest.



8. Turn the computer over and remove the hard drive (see Hard Drive).



9. Loosen the two captive screws located at the front of the hard drive bay.



10. Remove the seven M2.5 x 8-mm palm-rest screws from the bottom of the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface, such as a connector on the back of the computer.

NOTE: You can leave the coin-cell battery in place (on the palm rest) unless you are installing a replacement palm rest, in which case you need to

remove the coin-cell battery and place it in the replacement palm rest.

captive screws (2)

M2.5 x 8-mm palm-rest screws (7)



1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 42 43

Pas de commentaire

Dell D630 - LATITUDE ATG NOTEBOOK Guide de dépannage Page 32