Dell 5524 Guide de l'utilisateur Page 654

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 728
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 653
654 Dell PowerConnect 55xx Systems User Guide
Mapping DSCP Values to Queues Using CLI Commands
The following table summarizes the CLI commands for configuring fields in
the DSCP to Queue
page.
The following is an example of the CLI command:
Bandwidth
The amount of traffic that can be received and transmitted on an interface
can be limited by the following:
Ingress Rate Limit
— Number of bits per second that can be received
from the ingress interface. Excess bandwidth above this limit is discarded.
Egress Shaping Rates
is defined by the following:
Committed Information Rate (CIR) sets the average maximum
amount of data allowed to be sent on the egress interface, measured in
bits per second
Committed Burst Shape (CBS) sets the maximum burst of data that
is allowed to be sent, even though it is above the CIR. This is defined
in number of bytes of data.
Table 22-5. DSCP to Queue CLI Commands
CLI Command Description
qos map dscp-queue dscp-list to
queue-id
no qos map dscp-queue [dscp-
list]
Modifies the DSCP to queue
mapping.
Use the no form of this command to
restore the default configuration.
console(config)# qos map dscp-queue 33 40 41 to 1
Vue de la page 653
1 2 ... 649 650 651 652 653 654 655 656 657 658 659 ... 727 728

Commentaires sur ces manuels

Pas de commentaire