Use the Network menu to change printer settings affecting jobs sent to the printer through a network port.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet.
The change becomes effective after the printer is turned off and then on again.
Values:
Auto*
Detects the Ethernet settings automatically.
10Base Half
Uses 10base-T half-duplex.
10Base Full
Uses 10base-T full-duplex.
100Base Half
Uses 100base-TX half-duplex.
100Base Full
Uses 100base-TX full-duplex.
TCP/IP
Purpose:
To specify the TCP/IP settings.
The change becomes effective after the printer is turned off and then on again.
Values:
IP AddressSetup AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Displays the IP address allocated to the printer by using the keys on the operator panel.
Subnet Mask
Displays the subnet mask.
Displays the gateway address.
Commentaires sur ces manuels