Dell PowerEdge C6100 Manuel du propriétaire télécharger pdf (Page 105)

Installing System Components 105

Replace the screws that secure the mid-plane holder support to the chassis.

See Figure 3-28.

Place the upper midplane on the midplane holder. See Figure 3-27.

Replace the screws that secure the midplane to the midplane holder.

Figure 3-27.

Connect all the cables to the upper midplane. See Figure 5-9.

You must route these cables properly through the tabs on the chassis to

prevent them from being pinched or crimped.

Place the fan bracket into the chassis. Figure 3-26.

Replace the screws that secure the fan bracket to the chassis. Figure 3-26.

Replace the cooling fans. See "Installing a Cooling Fan" on page 94.

Replace the system-board assemblies. See "Installing a System-Board

Assembly" on page 62.

Close the system, see "Closing the System" on page 92.

Reconnect the system to its electrical outlet and turn on the system,

including any attached peripherals.

Backplanes

NOTE: Following is the replacement procedure of SATA2 and SAS backplane for

3.5-inch hard drive systems. Replacement procedure for 2.5-inch of SATA2 and

SAS backplane is similar to backplane for 3.5-inch hard drive systems.

Removing the Backplane

CAUTION: Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in

your product documentation, or as directed by the online or telephone service

and support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came

with the product.

Turn off the system, including any attached peripherals, and disconnect

the system from its electrical outlet.

Remove all the hard drives. See "Removing a Hard-Drive Carrier" on

page 56.

book.book Page 105 Thursday, March 4, 2010 4:38 PM

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 159 160

Pas de commentaire

Dell PowerEdge C6100 Manuel du propriétaire Page 105