Dell PowerEdge Rack Enclosure 4220 Manuel d'utilisateur télécharger pdf (Page 3)

Install the coupling brackets.

Position the two racks side by side.

Adjust the leveling feet on both racks so that the racks are parallel and in

the same horizontal plane. For instructions, see "Adjusting the Leveling

Feet" in your rack installation guide.

Install the four coupling brackets on the racks (two on the top and two

on the bottom) as shown in Figure 1-3.

Hook the brackets into the square holes inside and adjacent to the rack

posts, and tighten the brackets using the wing nuts (see Figure 1-3).

Figure 1-3. Coupling Two Racks

1 coupling bracket locations 2 wing nut

3 coupling bracket (4)

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

Dell PowerEdge Rack Enclosure 4220 Manuel d'utilisateur Page 3