Dell PowerEdge RAID Controller H800 Manuel d'utilisateur télécharger pdf (Page 2)

Figure 1-1. Removing and Installing the PERC Adapter

Replacing the BBU on a PERC 5/i, PERC 6/i, PERC H700, or PERC H800

Ensure that there is no preserved cache on the PERC adapter. See "Managing

Preserved Cache" on page 4.

Perform a controlled shutdown of the system and attached peripherals.

Disconnect the system from the electrical outlet and remove the system cover.

Remove the Battery Backup Unit (BBU) from the plastic mounting shroud

in your system and disconnect the battery cable.

Re-connect the BBU to the controller by inserting the end of the battery cable

into the connector on the controller.

1 PCI-E slot 2 PERC adapter

3 DIMM 4 tabs (2)

1 2 3 4 5 6 7 ... 55 56

Pas de commentaire

Dell PowerEdge RAID Controller H800 Manuel d'utilisateur Page 2