Dell PowerEdge C1100 Manuel d'utilisateur télécharger pdf (Page 60)

60 Installing System Components

If applicable, replace the expansion-card riser. See "Installing the

Expansion-Card Riser" on page 70.

Close the system. See "Closing the System" on page 56.

Reconnect the system and peripherals to their electrical outlets, and turn

on the system.

Processor

CAUTION: Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in

your product documentation, or as directed by the online or telephone service

and support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came

with the product.

Removing the Processor

Turn off the system, including any attached peripherals, and disconnect

the system from its electrical outlet.

Open the system. See "Opening the System" on page 55.

Remove the cooling shroud. See "Removing the Cooling Shroud" on

page 56.

Remove the heat sink. See "Removing the Heat Sink" on page 58.

CAUTION: The processor is held in its socket under strong pressure. Be aware

that the release lever can spring up suddenly if not firmly grasped.

Position your thumb firmly over the processor socket-release lever and

release the lever from the locked position. Rotate the lever 90 degrees

upward until the processor is released from the socket. See Figure 3-8.

Rotate the processor shield upward and out of the way.

book.book Page 60 Tuesday, February 26, 2013 11:33 AM

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 139 140

Pas de commentaire

Dell PowerEdge C1100 Manuel d'utilisateur Page 60