Dell PowerEdge R310 Manuel d'utilisateur télécharger pdf (Page 54)

54 Using the System Setup Program and UEFI Boot Manager

Entering the System Setup Program

Turn on or restart your system.

Press <F2> immediately after you see the following message:

<F2> = System Setup

If your operating system begins to load before you press <F2>, allow the

system to finish booting, and then restart your system and try again.

Responding to Error Messages

If an error message appears while the system is booting, make a note of the

message. See "System Messages" on page 38 for a description of the message

and suggestions for correcting errors.

NOTE: After installing a memory upgrade, it is normal for your system to display a

message the first time you start your system.

Using the System Setup Program Navigation Keys

NOTE: For most of the options, any changes that you make are recorded but do not

take effect until you restart the system.

Keys Action

Up arrow or <Shift><Tab> Moves to the previous field.

Down arrow or <Tab> Moves to the next field.

<Enter>, Spacebar, <+>,

–>, left and right arrows

Cycles through the settings in a field. In many

fields, you can also type the appropriate value.

<Esc> Exits the System Setup program and restarts the

system if any changes were made.

<F1> Displays the System Setup program

's help file.

R310HOM.book Page 54 Thursday, March 4, 2010 1:03 AM

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 175 176

Pas de commentaire

Dell PowerEdge R310 Manuel d'utilisateur Page 54