Dell Lifecycle Controller 1.2 for Linux Guide de l'utilisateur télécharger pdf (Page 156)

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0

156

-h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD -J SetAttribute_CNA_IscsiOffloadMode.xml

-j utf-8 -y basic

The information in the input file SetAttribute_NIC.xml is shown below:

<p:SetAttributes_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_NICService">

<p:Target>NIC.Integrated.1-1-1</p:Target>

<p:AttributeName>IscsiOffloadMode</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

</p:SetAttributes_INPUT>

OUTPUT:

<n1:SetAttribute_OUTPUT>

<n1:Message>The command was successful</n1:Message>

<n1:MessageID>NIC001</n1:MessageID>

<n1:RebootRequired>Yes</n1:RebootRequired >

<n1:ReturnValue>0</n1:ReturnValue>

<n1:SetResult>Set PendingValue</n1:SetResult >

</n1:SetAttribute_OUTPUT>

15.11 Setting the MaxBandwidth Attribute

The SetAttribute() method is used to set or change the value of a CNA attribute.

The MinBandwidth and MaxBandwidth attributes control the bandwidth allocations for a given CNA

partition. The values are displayed in percentage.

For Broadcom CNA cards, the MinBandwidth attribute values for a given port must always add up to

either 0 or 100. MaxBandwidth is a value of 100 or less for any given partition.

For the Qlogic CNA cards, the MinBandwidth attribute values for a given port must add up to 100 or

less. MaxBandwidth again is a value of 100 or less for any given partition.

Invoke SetAttribute() with the following parameters(from Section 15.1) and syntax:

Target: FQDD attained through DCIM_NICInteger

AttributeName: Attained from AttributeName field

AttributeValue: A new value to assign to the specified NICAttribute. If this value is valid, it is

applied to the PendingValue property or the Currentvalue property of the specified

NICAttribute. Range of choices is attained from the LowerBound and UpperBound fields:

LowerBound = 0

UpperBound = 100

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 252 253

Pas de commentaire

Dell Lifecycle Controller 1.2 for Linux Guide de l'utilisateur Page 156