Dell Lifecycle Controller 1.2 for Linux Guide de l'utilisateur télécharger pdf (Page 184)

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0

184

<p:LockVirtualDisk_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_RAIDService">

<p:Target>Disk.Virtual.0:RAID.Integrated.1-1</p:Target>

</p:LockVirtualDisk_INPUT>

OUTPUT:

This method requires an H700 or H800 controller to properly function, as does the LockVirtualDisk()

method. If the key is not set by LockVirtualDisk(), the following message may be displayed:

<n1:LockVirtualDisk_OUTPUT>

<n1:Message>Controller is not security capable</n1:Message>

<n1:MessageID>STOR022</n1:MessageID>

<n1:ReturnValue>2</n1:ReturnValue>

<n1:LockVirtualDisk_OUTPUT>

16.17.3 Locking the Controller with a Key-EnableControllerEncryption()

The EnableControllerEncryption() method is used to set either Local Key encryption or Dell Key

Manager (DKM) encryption on controllers that support encryption of the drives.

Invoke EnableControllerEncryption() method with the following parameters and syntax:

TARGET: This parameter is the FQDD of the DCIM_ControllerView class. See Section 16.1.

Key: Key – Passcode. This parameter is required if the Mode = Local Key

Encryption. The Key can be maximum 32 characters in length, and must

have one character from each of the following sets.

Upper Case

Lower Case

Number

Special Character

The special characters in the following set needs to be passed as mentioned

below.

&  &

<  <

>  >

“  "

‘  '

Keyid: Key Identifier- Describes Key. The Keyid can be maximum 32 characters in length and

must not have spaces in it.

Mode: Mode of the Controller

1 - Local Key Encryption

2 – Dell Key Manager

EXAMPLE:

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 252 253

Pas de commentaire

Dell Lifecycle Controller 1.2 for Linux Guide de l'utilisateur Page 184