Dell Lifecycle Controller 1.2 for Linux Guide de l'utilisateur télécharger pdf (Page 198)

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0

198

Address = http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anonymous

ReferenceParameters

ResourceURI = http://schemas.dell.com/wbem/wscim/1/cim-schema/2/DCIM_VirtualDiskView

SelectorSet

Selector: InstanceID = DISK.Virtual.267386880:RAID.Integrated.1-1, __cimnamespace =

root/dcim

RebootRequired = YES

ReturnValue = 0

16.18.7 Deleting a Virtual Disk-DeleteVirtualDisk()

The DeleteVirtualDisk() method is used to delete a single virtual disk from the targeted controller. The

successful execution of this method results in the marking of this virtual disk for deletion. The

ObjectStatus property in the virtual disk view will have the value of ‘2’, which indicates pending

delete. The virtual disk will not be deleted until a configuration job is scheduled and the system is

rebooted (Section 16.15).

Invoke DeleteVirtualDisk() with the following parameters and syntax:

TARGET: This parameter is the FQDD of the virtual device (Section 16.10)

EXAMPLE:

wsman invoke -a DeleteVirtualDisk http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_RAIDService

?SystemCreationClassName=DCIM_ComputerSystem,

CreationClassName=DCIM_RAIDService,SystemName=DCIM:ComputerSystem,

Name=DCIM:RAIDService -h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD -J DeleteVirtualDisk.xml -j utf-8 -y basic

The input file DeleteVirtualDisk.xml is shown below:

<p:DeleteVirtualDisk_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_RAIDService">

<p:Target>DISK.Virtual.0:RAID.Integrated.1-1</p:Target>

</p:DeleteVirtualDisk_INPUT>

OUTPUT:

<n1:DeleteVirtualDisk_OUTPUT>

<n1:RebootRequired>Yes</n1:RebootRequired>

<n1:ReturnValue>0</n1:ReturnValue>

</n1:DeleteVirtualDisk_OUTPUT>

16.19 Setting Controller Attributes

16.19.1 Changing the Value of a RAID Controller Enumeration Attribute

The SetAttribute() method is used to set or change the value of a RAID controller or a virtual disk

attribute. The example below shows setting a RAID controller enumeration attribute. To set a virtual

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 252 253

Pas de commentaire

Dell Lifecycle Controller 1.2 for Linux Guide de l'utilisateur Page 198