Dell Lifecycle Controller 2 Version 1.3.0 Manuel de service télécharger pdf (Page 52)

<wsman:ResourceURI>http://schemas.dell.com/wbem/wscim/1/cimschema/

2/DCIM_SoftUpdateConcreteJob</wsman:ResourceURI>

<wsman:SelectorSet>

<wsman:Selector Name="InstanceID">RID_001299756950</wsman:Selector>

<wsman:Selector Name="__cimnamespace">root/dcim</wsman:Selector>

</wsman:SelectorSet>

</wsa:ReferenceParameters>

</n1:RebootJobID>

<n1:ReturnValue>4096</n1:ReturnValue>

</n1:CreateRebootJob_OUTPUT>

The jobid in the above output is the instanceID:

Jobid = InstanceID = RID_001265648530

7.9 Automatic Updates

Automatic Updates feature allows for periodic firmware updates at regular intervals as configured by

the user.

7.9.1 Enable automatic update

This method enables or disables the “Automatic Update Feature ” attribute.

Example:

wsman invoke -a SetAttribute http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_LCService

?SystemCreationClassName=DCIM_ComputerSystem,CreationClassName=DCIM_LCService,SystemName

=DCIM:ComputerSystem,Name=DCIM:LCService -h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD -J SetAttribute_LC.xml -j utf-8 -y basic

The SetAttribute_LC.xml file is as follows:

<p:SetAttribute_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_LCService">

<p:AttributeName>Automatic Update Feature</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

</p:SetAttribute_INPUT>

OUTPUT:

<n1:SetAttribute_OUTPUT>

<n1:RebootRequired>No</n1:RebootRequired>

<n1:ReturnValue>0</n1:ReturnValue>

<n1:SetResult>Set PendingValue</n1:SetResult>

</n1:SetAttribute_OUTPUT>

7.9.2 Create a Config Job

CreateConfigJob sets the pending value set by SetAttribute() method.

Example:

wsman invoke -a CreateConfigJob http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_LCService

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 239 240

Pas de commentaire

Dell Lifecycle Controller 2 Version 1.3.0 Manuel de service Page 52