Dell Lifecycle Controller 2 Version 1.3.0 Manuel de service télécharger pdf (Page 98)

11.3.20 Get RFS ISO Image Connection Information

The GetRFSISOImageConnectionInfo() method is used to provide the status of the ISO Image

connection that has been made available to the host system.

Invoke GetRFSISOImageConnectionInfo() with the following syntax:

EXAMPLE:

wsman invoke -a GetRFSISOImageConnectionInfo

http://schemas.dmtf.org/wbem/wscim/1/cimschema/

2/root/dcim/DCIM_OSDeploymentService

?CreationClassName=DCIM_OSDeploymentService,

Name=DCIM:OSDeploymentService,

SystemCreationClassName=DCIM_ComputerSystem,

SystemName=DCIM:ComputerSystem

-h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD -j utf-8 -y basic

OUTPUT:

<n1:GetRFSISOImageConnectionInfo_OUTPUT>

<n1:Message>Unable to connect to ISO using RFS.</n1:Message>

<n1:MessageID>OSD60</n1:MessageID>

<n1:ReturnValue>2</n1:ReturnValue>

</n1:GetRFSISOImageConnectionInfo_OUTPUT>

A return value 0 indicates success, the above output indicates an image was not present to

retrieve the connection information from.

11.3.21 Boot To Hard Drive (HD)

The BootToHD() method is used for one time boot to hard disk drive of the host server. After this

method is ran, the host is rebooted immediately and will boot to the first configured hard disk drive

irrespective of its boot order.

Invoke BootToHD() with the following syntax:

EXAMPLE:

wsman invoke -a BootToHD http://schemas.dmtf.org/wbem/wscim/1/cimschema/

2/root/dcim/DCIM_OSDeploymentService

?CreationClassName=DCIM_OSDeploymentService,

Name=DCIM:OSDeploymentService,

SystemCreationClassName=DCIM_ComputerSystem,

SystemName=DCIM:ComputerSystem

-h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD -j utf-8 -y basic

OUTPUT:

<n1:BootToPXE_OUTPUT>

<n1:ReturnValue>0</n1:ReturnValue>

</n1:BootToPXE_OUTPUT>

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 239 240

Pas de commentaire

Dell Lifecycle Controller 2 Version 1.3.0 Manuel de service Page 98