Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Manuel d'utilisateur télécharger pdf (Page 19)

Configuring Boot From SAN Using iSCSI-Based Dell Storage Arrays

10. Press <ESC> once to return to the Main Menu. Ensure that there is no information entered for

either 2nd Target Parameters or Secondary Device Parameters.

11. Press <ESC> once more to leave the iSCSI Configuration Utility. IMPORTANT: Be sure to save the

configuration.

12. Press <ESC> one more time to the MBA Configuration menu, and press <F4> to save your changes

and exit.

NOTE: Ensure that the Windows 2008 installation DVD is in the drive.

13. Upon exiting the Broadcom utility, the server should immediately try to connect to the iSCSI

target. Continue with the Windows® installation.

Configuring the Intel Network Adapter

To prepare the system to boot from an iSCSI-based LUN, you must enable the iSCSI remote boot feature

in the NIC option ROM, modify the Integrated Devices setting in the server BIOS, then setup the iSCSI

boot configuration on the NIC.

Enable iSCSI Remote Boot in the NIC Boot ROM

The Intel NICs are not shipped with Boot ROMs enabled for iSCSI. You must perform the following steps

to enable iSCSI remote boot in the Boot ROM on the NIC.

1. Create a DOS-bootable USB flash drive.

2. Extract both the Intel Boot Agent Utility (ProBoot.exe) and the Intel iSCSI Remote Boot Utility

(ISBoot.exe) to the bootable USB flash drive in separate directories.

3. With the Intel NIC installed, boot the server using the DOS-bootable USB flash drive.

Page 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Pas de commentaire

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Manuel d'utilisateur Page 19