Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Manuel d'utilisateur télécharger pdf (Page 31)

Configuring Boot From SAN Using iSCSI-Based Dell Storage Arrays

14. In the Main Menu, select General Parameters and then set the following parameters:

TCP/IP parameters via DHCP Disabled

iSCSI parameters via DHCP Disabled

CHAP Authentication Disabled

Boot to iSCSI target Disabled (when installing image), Enabled (after cloning or

installing image to boot from iSCSI target)

DHCP Vendor ID BRCM ISAN

Link Up Delay Time 0

Use TCP Timestamp Disabled

Target as First HDD Disabled (if using Imaging with Local Disk), Enabled (if using

Direct or Remote Install)

LUN Busy Retry Count 0

IP Version IPV4 or IPV6

Windows HBA Boot Mode Disabled (not applicable for Linux)

NOTE: You must ensure that all network settings are properly configured. For example, if you

enable CHAP in the target but you do not enable it in the Primary or Secondary path (or vice

versa), a blue screen will result.

NOTE: If you wish to use OIS to boot, set Windows HBA Boot Mode to Enabled. You will need a

license key to enable offload features. For additional information, see the Broadcom

NetXtreme Family of Adapters User's Guide.

NOTE: To use DHCP for dynamically-assigned settings, set the TCP/IP and the iSCSI parameters

through DHCP to Enabled. For additional information, see the Broadcom NetXtreme Family of

Adapters User's Guide.

NOTE: Do not enable CHAP at this time. It is recommended that you configure advanced

features after the connection between the host and target is established.

15. Press <ESC> to return to the Main Menu.

Page 29

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Manuel d'utilisateur Page 31