Dell Force10 S60-44T Manuel d'installation Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 45
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Install the S60 System | 12
To attach the brackets to the chassis, follow these steps:
Install the Chassis into the Rack or Cabinet
To permit access and airflow, ensure that there is adequate clearance surrounding the rack or within the
cabinet. When you install two S60 systems near each other, to permit proper airflow, position the two
chassis at least five inches (12.7 cm) apart.
To install a switch into a two-post 19-inch equipment rack, using the already attached mounting brackets,
follow these steps:
Step Task
1 Take the brackets and screws out of their packaging.
2 Attach the brackets to the rear sides of the chassis using four screws for each bracket. Attach the bracket so that
the “ear” faces to the rear and the outside of the chassis.
Step Task
NOTE: Dell Networking recommends one person holding the S60 chassis in place while another person
attaches the brackets to the posts.
1 Attach the bracket “ears” to the rack or cabinet posts using two screws for each bracket. Ensure the screws are
tightened firmly.
Power Supply
Power Supply
Screws
Connect to
rack/cabinet
(ear)
Connect to
rack/cabinet
(ear)
View of chassis front
View from chassis rear
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 44 45

Commentaires sur ces manuels

Pas de commentaire