Dell Force10 S60-44T Manuel d'installation Page 30

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 45
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 29
Access the Console Ports | 30
To access the USB-B console port, follow these steps:
Step Task
1 Power on the PC (Dell Force 10 recommends using an XP operating system).
2 Connect the USB-A end of cable (included) into an available USB port on the PC.
3 Connect the USB-B end of cable into the USB-B console port on the S60 system.
4 Power on the S60 system.
5 Install the necessary USB device drivers (an internet connection is required). For assistance, contact Dell
Networking Technical Support.
6 Open your terminal software emulation program to access the S60 system.
7 Set the terminal connection settings as follows:
9600 baud rate
No parity
8 data bits
•1 stop bit
No flow control
8 The CLI command prompt appears when you are connected to the S60 system.
Vue de la page 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 44 45

Commentaires sur ces manuels

Pas de commentaire