Dell PowerEdge 2600 Manuel d'utilisateur télécharger pdf (Page 11)

Removing the System From the Rack

CAUTION: If you are removing more than one system from the rack cabinet,

remove the highest of the systems to be removed first. Complete the removal of

the first system from the rack before starting the second. Never extend more

than one system from the rack at a time.

CAUTION: Removing a system from a position high up in the rack cabinet will

require up to four people and may require a sturdy, elevated platform to stand

on. A mechanical lifting platform or similar equipment of the proper capacity

may also be useful. If you attempt to remove and lower the system without

enough people to safely perform the task, you risk personal injury to yourself

and to others and damage to the system.

1 Loosen the thumbserews that seeure the front panel to the front vertieal rails (at the

front of the raek eabinet).

2 Pull the system out of the raek on its slide assemblies until the slide assembly loek

snaps into plaee at the fully-extended position.

3 Press up on the yellow system release lateh and pull the system toward the front and to

the outermost position on the slide assemblies (see Figure 1-5).

* Using two to four people, grasp the system at eaeh eorner and lift the system up and

out of the slide assemblies (see Figure 1-5).

The shoulder serews should lift out of the outermost slide seetion. If you have

diffieulty, make eertain that the shoulder serews in the slide assembly are aligned with

their opening on the top of the slide.

5 Plaee the system on a smooth work surfaee.

Rack-to-Tower Conversion Guide | 1-7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 89 90

Pas de commentaire

Dell PowerEdge 2600 Manuel d'utilisateur Page 11