Dell PowerEdge T300 Manuel d'utilisateur télécharger pdf (Page 92)

92 Installing System Components

Figure 3-19. Installing Optical or Tape Drive Shoulder Screws

From the front of the system, align the shoulder screws with the slot in the

chassis, then slide the drive into the drive bay until the shoulder screw

snaps into place or you feel the drive securely installed (see Figure 3-18).

Attach the SCSI power cable (see Figure 3-17) or SATA power cable (see

Figure 3-18) to the drive.

Attach the data cable:

• If you are installing a SATA optical drive (see Figure 3-18), connect

the cable from the SATA connector on the drive to the appropriate

SATA connector on the system board (see "System Board Connectors"

on page 167).

• If you are installing a SCSI tape drive, connect the SCSI interface

cable (see Figure 3-17) in the drive kit from the SCSI controller card

to the drive.

Replace the processor airflow shroud (see "Installing the Processor Airflow

Shroud" on page 72).

1 screws (3)

book.book Page 92 Sunday, June 21, 2009 10:04 AM

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 193 194

Pas de commentaire

Dell PowerEdge T300 Manuel d'utilisateur Page 92