Dell PowerEdge T300 Manuel d'utilisateur Page 99
- Page / 194
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Installing System Components 99
NOTICE: Do not route card cables over or behind the cards. Cables routed over the
cards can prevent the system cover from closing properly or cause damage to the
equipment.
9
Using the appropriate interface cable, connect the SAS controller card
(connector 0) directly to the internal hard drives or to the SAS backplane,
if installed.
NOTE: The cable must be connected according to the connector labels on
the cable. The cable does not operate if reversed.
10
Connect the SAS cable, LED cable, and RAID battery cable (if applicable)
to the SAS controller card.
NOTE: For battery-cached SAS/RAID controllers, install the RAID battery (see
"Installing a RAID Battery" on page 102).
11
Close the expansion card cover (see Figure 3-7).
12
Replace the system cover (see "Installing the System Cover" on page 67).
13
Reattach any peripherals you disconnected, then connect the system to
the electrical outlet.
14
Turn on the system and attached peripherals.
15
Install any device drivers required for the card.
See the documentation for the card for information about installing the
card’s device drivers.
RAID Battery
The information in this section applies only to systems with the optional
battery-cached SAS/RAID controller card.
Removing a RAID Battery
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
book.book Page 99 Sunday, June 21, 2009 10:04 AM
- Dell™ PowerEdge™ T300 Systems 1
- Hardware Owner’s Manual 1
- Notes, Notices, and Cautions 2
- Contents 3
- 4 Contents 4
- 6 Contents 6
- 8 Contents 8
- 10 Contents 10
- About Your System 11
- 14 About Your System 14
- Connecting External Devices 16
- Power Indicator Codes 17
- NIC Indicator Codes 18
- LCD Status Messages 19
- 20 About Your System 20
- 22 About Your System 22
- NOTE: The LCD continues 22
- 24 About Your System 24
- 26 About Your System 26
- 28 About Your System 28
- Removing LCD Status Messages 29
- System Messages 30
- 32 About Your System 32
- 34 About Your System 34
- 36 About Your System 36
- 38 About Your System 38
- Warning Messages 40
- Diagnostics Messages 40
- Alert Messages 40
- Responding to Error Messages 41
- System Setup Options 43
- Memory Information Screen 45
- CPU Information Screen 46
- SATA Configuration Screen 47
- Integrated Devices Screen 48
- Serial Communication Screen 49
- System Security Screen 50
- Exit Screen 52
- Using the System Password 53
- Using the Setup Password 56
- Entering the BMC Setup Module 58
- BMC Setup Module Options 58
- Recommended Tools 60
- Inside the System 60
- Front Bezel 62
- Removing the Front Bezel 63
- Installing the Front Bezel 64
- Front Bezel Inserts 65
- System Cover 66
- Installing the System Cover 67
- EMI Fillers 68
- Processor Airflow Shroud 69
- 7 cable guides (4) 72
- Hard Drives 77
- Removing a Cabled Hard Drive 80
- Configuring the Boot Device 84
- Diskette Drive (Optional) 84
- Installing a Diskette Drive 86
- 1 shoulder screws (4) 87
- Optical and Tape Drives 88
- 1 screws (3) 92
- Expansion Cards 93
- Installing an Expansion Card 95
- SAS Controller Card 96
- RAID Battery 99
- Installing System Components 100
- Installing a RAID Battery 102
- Removing the RAC Card 102
- Installing a RAC Card 104
- Cooling Fans 107
- Removing the System Fan 109
- Installing the System Fan 110
- System Memory 111
- Removing Memory Modules 112
- Installing Memory Modules 113
- Processor 115
- Installing the Processor 118
- System Battery 119
- Chassis Intrusion Switch 121
- SAS Backplane 125
- Control Panel 127
- System Board 129
- Installing the System Board 131
- Troubleshooting Your System 133
- Checking the Equipment 134
- Troubleshooting a USB Device 138
- Troubleshooting a NIC 140
- Troubleshooting a Wet System 141
- Troubleshooting a Fan 145
- Troubleshooting System Memory 146
- Troubleshooting a Hard Drive 153
- System Diagnostics Features 163
- Using the Custom Test Options 165
- Selecting Diagnostics Options 166
- Jumpers and Connectors 167
- 168 Jumpers and Connectors 168
- Jumper Settings 170
- 172 Jumpers and Connectors 172
- 174 Jumpers and Connectors 174
- Getting Help 175
- 176 Getting Help 176
- Glossary 177
- 178 Glossary 178
- 180 Glossary 180
- 182 Glossary 182
- 184 Glossary 184
- 186 Glossary 186
- 188 Glossary 188
- Numerics 189
- Index 191 191
- Index 193 193
Produits connexes et manuels pour Matériel informatique Dell PowerEdge T300
(92 pages)
(50 pages)
© 2020, manymanuals.fr. Tous droits réservés | 1.497 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels