Dell PowerEdge M710 Manuel d'utilisateur Page 322

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 368
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 321
322 Troubleshooting Your System
14
For each expansion card you removed in step 10, perform the following
steps:
a
Open the blade. See "Opening the Blade" on page 159.
b
Reinstall one of the expansion cards.
c
Close the blade. See "Closing the Blade" on page 161.
d
Install the blade and turn it on. See "Installing a Blade" on page 158.
e
Run the appropriate diagnostic test.
15
For M610x only, if the problem persists after reseating the expansion cards,
reseat the power and data cables and run the appropriate diagnostic test.
16
If the tests fail, see "Getting Help" on page 361.
Troubleshooting Processors
1
Remove the blade. See "Removing a Blade" on page 155.
2
Open the blade. See "Opening the Blade" on page 159.
3
Ensure that the processor(s) and heat sink(s) are properly installed. See
"Processors" on page 243.
4
If your system only has one processor installed
, ensure that it is installed in
the primary processor socket. See Figure 7-13 or Figure 7-12.
5
For a PowerEdge M905 system
, check that hypertransport (HT) bridge
cards are installed in sockets CPU3 and CPU4, and that both cards are
fully seated in the processor sockets. See "HT Bridge Card (PowerEdge
M905 Only)" on page 262.
6
Close the blade. See "Closing the Blade" on page 161.
7
Install the blade. See "Installing a Blade" on page 158.
8
Run
Quick Tests
in the system diagnostics. See "Running System
Diagnostics" on page 325.
If the tests fail or the problem persists, see "Getting Help" on page 361.
Vue de la page 321
1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 367 368

Commentaires sur ces manuels

Pas de commentaire