Dell Networking Z9500 Manuel d'installation télécharger pdf (Page 10)

Utility Panel

The Utility panel side of the platform contains the fan and power modules.

Figure 2. Utility Side

1. Fan Trays 2. Power Supplies

Power Supplies

The Z9500 supports four hot-swappable Power supply units (PSUs) .

NOTE: The PSUs must be installed at the customer site.

PSUs are field replaceable. To ensure power redundancy and adequate cooling, install four power

supplies in the switch. When running with full redundancy (four PSUs installed and running), you can

remove and replace a PSU while the other PSUs are running without disrupting traffic.

Fans

The Z9500 supports five fan trays with airflow directions from I/O to Utility.

The fans must be installed at the customer site.

System Status

You can view Z9500 status information in several ways, including:

• LEDs

• CLI show commands

• Simple network management protocol (SNMP)

For more information about these options, refer to the Dell Networking Command Line Reference Guide

and Dell Networking Configuration Guide for the Z9500 Switch.

As shown in the following figure, the Z9500 includes LED displays on the I/O and Utility side of the

chassis. When the Z9500 powers up or reloads, the status LED on the power supplies are solid green.

Hardware Overview

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Pas de commentaire

Dell Networking Z9500 Manuel d'installation Page 10