Dell Networking Z9500 Manuel d'installation télécharger pdf (Page 14)

Site Preparation

The Z9500 is suitable for installation as part of a Common Bond Network (CBN). It can be installed in:

• network telecommunication facilities

• data centers

• other locations where the National Electric Code (NEC) applies

This chapter contains the following sections:

• Site Selection

• Cabinet Placement

• Storing Components

Site Selection

Dell Networking equipment is intended for installation in restricted access areas. A restricted access area

can only be accessed by service personnel by using a special tool, lock, key or other means of security

and access is controlled by the authority responsible for the location.

Ensure that the area where you install your Z9500 system meets the following safety requirements:

• Near an adequate power source. Connect the system to the appropriate branch circuit protection as

defined by your local electrical codes.

• Environmental temperature between 32° to 104°F (0° to 40°C).

• Humidity that does not exceed 85 percent noncondensing.

• In a dry, clean, well-ventilated and temperature-controlled room, away from heat sources such as hot

air vents or direct sunlight.

• Away from sources of severe electromagnetic noise.

• Positioned in a rack or cabinet, or on a desktop with adequate space in the front, rear, and sides of the

Z9500 for proper ventilation and access.

Cabinet Placement

Install the Z9500 only in indoor cabinets designed for use in a controlled environment as described in Site

Selection.

The cabinet must meet the following criteria:

• Minimum cabinet size and airflow are according to the Electronic Industries Alliance (EIA) standard.

Site Preparation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Pas de commentaire

Dell Networking Z9500 Manuel d'installation Page 14