Dell PowerVault MD3000 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel informatique Dell PowerVault MD3000. Dell PowerVault MD3000 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Dell™ PowerVault™
MD3000/MD3000i RAID Controller
Password Reset
Perform this procedure when you have lost or forgotten your password and you
need to reset it.
Connecting the Serial Cable
1
Remove the serial cable from the password reset cable package.
2
Connect the DB9 (oval) end of the cable to the serial port on the computer to
be used to communicate with the RAID Controller module.
3
Connect the PS2-type (round) end of the cable to the serial port on either of
the array’s RAID Controller Modules. The flat side of the connector faces
down when inserting.
System Setup
Microsoft
®
Windows
®
Operating Systems
1
Click
Start
Programs
Accessories
Communication
HyperTerminal
to
run HyperTerminal.
If HyperTerminal is not installed, click
Control Panel
Add/Remove
Programs
Add/Remove Windows Components
, find
HyperTerminal
and
click the check-box, then click
Apply
and
OK
.
NOTE: The original Windows installation disk may be needed to install
HyperTerminal.
NOTE: If you are running Windows Vista
®
or Windows Server
®
2008,
HyperTerminal is not included in the operating system. To complete these steps, a
third-party terminal emulation program is required.
March 2009
52933A00.fm Page 9 Thursday, March 19, 2009 9:56 AM
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Password Reset

Dell™ PowerVault™ MD3000/MD3000i RAID Controller Password ResetPerform this procedure when you have lost or forgotten your password and you need to re

Page 2 - Reset Password

2When HyperTerminal prompts for a name, type MD3000 or MD3000i and click OK. Select the COM1 port and click OK.3Set the following communication settin

Page 3

RAID Controllers Using First-Generation Firmware (Version 06.xx.xx.xx) CAUTION: Failure to stop data I/O to a non-fault-tolerant array before perform

Page 4 - Interface Menu

3When prompted for input within 5 seconds, press <S> for the Service Interface Menu. NOTE: The "S" must be capitalized. A lower-case

Commentaires sur ces manuels

Pas de commentaire