Dell OpenManage Server Administrator Managed Node for Fluid Cache for DAS Manuel d'utilisateur télécharger pdf (Page 279)

omconfig storage Commands 279

Example Syntax

To reset the thresholds for temperature probe 3, residing in the enclosure

attached to connector 2 on controller 1, to the default values:

• For SCSI, SATA, and ATA controllers:

omconfig storage enclosure action=resettempprobes

controller=1 enclosure=2 index=3

NOTE: Here, temperature probe 3 resides in the enclosure attached to connector 2

on controller 1.

omconfig Set All Temperature Probe Thresholds

Use the following omconfig command syntax to set the minimum and

maximum warning temperature thresholds for all temperature probes in the

enclosure.

NOTE: This command is not supported on SCSI RAID controllers.

Complete Syntax

omconfig storage enclosure action=setalltempprobes

controller=id enclosure=<ENCLOSUREID> minwarn=n

maxwarn=n

where id is the controller ID. The <ENCLOSUREID> variable specifies the

enclosure.

Example Syntax

To set the thresholds for all temperature probes residing in enclosure 3

attached to connector 2 on controller 1, to 10 and 40

degree Celsius:

• For SAS controllers:

omconfig storage enclosure action=setalltempprobes

controller=1 enclosure=2:3 minwarn=10 maxwarn=40

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 315 316

Pas de commentaire

Dell OpenManage Server Administrator Managed Node for Fluid Cache for DAS Manuel d'utilisateur Page 279