Dell Dimension 9200 Manuel d'utilisateur télécharger pdf (Page 46)



7. Place the heat-sink assembly on its side in a safe place.



8. Disconnect the system fan cable from the system board.



9. Ensure that all cables have been removed from the routing clips on the top of the system fan assembly.



10. Lift the fan release lever, then slide the fan toward the back of the computer to release the four fan tabs from the four keyhole slots in the bottom

cover.



11. Remove the fan from the computer.



Installing the Processor Fan

When reinstalling the fan, ensure that you do not pinch the wires that run between the system board and the fan.

Follow the removal procedure (Removing the Processor Fan) in reverse order.

Card Fan



heat sink and fan shroud assembly

captive screw housing (2)

fan release lever

fan release lever tab

processor fan

card fan



NOTICE: Ensure that the four fan tabs are fully inserted into the four keyhole slots in the bottom cover so that the fan can slide back fully into position.

Ensure that the fan release lever tab is seated into its slot in the bottom cover.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 62 63

Commentaires sur ces manuels

Pas de commentaire

Dell Dimension 9200 Manuel d'utilisateur Page 46

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Dell Dimension 9200