Back to Contents Page
Infrared Blaster Connector (Optional)
Dell™Inspiron™One2205ServiceManual
Removing the Infrared (IR) Blaster Connector
Replacing the Infrared (IR) Blaster Connector
Removing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You Begin.
2. Follow the instructions from step 2 to step 9 in Removing the System-Board Shield.
3. Remove the nut that secures the IR blaster to the system-board shield.
4. Release the IR blaster connector from the slot on the system-board shield.
5. Lift the IR blaster connector along with its cable away from the system-board shield.
Replacing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You Begin.
2. Slide the IR blaster connector into the slot on the system-board shield.
3. Replace the nut that secures the IR blaster connector to the system-board shield.
4. Follow the instructions from step 4 to step 11 in Replacing the System-Board Shield.
5. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Commentaires sur ces manuels