Dell Networking S6000 System Guide d'installation télécharger pdf (Page 30)

30 | Install the S6000

www.dell.com | support.dell.com

NOTE: S6000 ships with two PSUs. However, it is possible to run the unit with a single PSU. If you use a

single PSU, install a blank plate in the other PSU slot. Dell Networking recommends using power supply 1

(PSU1) as the blank plate slot.

To install an AC or DC power supply, follow these steps:

NOTE: The system powers up as soon as the cables are connected between the power supply and the power

source.

Step Task

Remove the PSU slot cover from the S6000 (PSU side of switch), either of the two PSU slots may be selected.

Remove the PSU from the electrostatic bag.

3 Insert the PSU into the switch PSU slot (insert the PSU-exposed PCB edge connector first). The PSU slot is keyed

such that the PSU can only be fully inserted in one orientation.

1 - Slot 1

2 - PSU 1

When you install the PSU correctly it should snap into place and be flush with the back of the switch.

Plug in the appropriate cord (AC 3 prong or DC wiring) from the switch PSU to the external power source (either

AC wall outlet or DC rack bus bar).

If you have a redundant PSU (2nd PSU), repeat steps 1 through 5 above using the 2nd PSU slot on the S6000

system.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 55 56

Pas de commentaire

Dell Networking S6000 System Guide d'installation Page 30