Dell OpenManage Server Administrator Version 5.4 Manuel d'utilisateur télécharger pdf (Page 194)

192 Using the Storage Management Service

Example for SCSI, SATA, and ATA Controllers

In this example, temperature probe 3 resides in the enclosure attached to

connector 2 on controller 1. To set the temperature probe thresholds to

10 and 40° Celsius, enter:

omconfig storage enclosure action=settempprobes

controller=1 enclosure=2 index=3 minwarn=10

maxwarn=40

omconfig Reset Temperature Probe Thresholds

Use the following omconfig command syntax to reset the minimum and

maximum warning temperature thresholds back to their default values.

NOTE: This command is not supported on SAS controllers.

Complete Syntax

omconfig storage enclosure action=resettempprobes

controller=id enclosure=<ENCLOSUREID> index=id

where id is the controller ID and the temperature probe ID. The

<ENCLOSUREID> variable specifies the enclosure.

Example Syntax

For example, you may want to reset the thresholds for temperature probe 3 to

the default values.

Example for SCSI, SATA, and ATA Controllers

In this example, temperature probe 3 resides in the enclosure attached to

connector 2 on controller 1. To reset the thresholds for temperature probe 3

to the default values, enter:

omconfig storage enclosure action=resettempprobes

controller=1 enclosure=2 index=3

omconfig Set All Temperature Probe Thresholds

Use the following omconfig command syntax to set the minimum and

maximum warning temperature thresholds for all temperature probes in the

enclosure.

NOTE: This command is not supported on SCSI RAID controllers.

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 257 258

Pas de commentaire

Dell OpenManage Server Administrator Version 5.4 Manuel d'utilisateur Page 194