Dell OptiPlex GX270 Manuel d'utilisateur télécharger pdf (Page 130)





Installing an AGP/DVI Adapter Card

1. To add or replace the card, press the card lever toward the PCI connector and gently press the card into the AGP connector until it clicks into place.

2. Release the card lever, ensuring that the tab fits into the notch on the front end of the card.

3. Secure the card by lowering the hinged lever on the back panel.

4. Close the computer cover.

5. Connect the monitor cable to the card's video connector.



6. Connect your computer and devices to electrical outlets, and turn them on.

After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next

computer start-up:



ALERT! Cover was previously removed.

7. Reset the chassis intrusion detector by changing Chassis Intrusion to Enabled or Enabled-Silent.



Back to Contents Page



notch

card clip

lever

AGP connector

tab

PCI connector

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion

detector.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 177 178

Commentaires sur ces manuels

Pas de commentaire

Dell OptiPlex GX270 Manuel d'utilisateur Page 130

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Dell OptiPlex GX270