Dell Inspiron 6000 Manuel d'utilisateur télécharger pdf (Page 38)

Back to Contents Page

 Microprocessor Thermal-Cooling Assembly

DellInspiron™6000ServiceManual

Removing the Microprocessor Thermal-Cooling Assembly

Replacing the Microprocessor Thermal-Cooling Assembly

Removing the Microprocessor Thermal-Cooling Assembly



1. Follow the instructions in "Preparing to Work Inside the Computer."



2. Remove the Mini PCI card (if applicable) and the optical drive.



3. Remove the hard drive.



4. Remove the hinge cover.



5. Remove the keyboard.



6. Remove the display assembly.



7. Remove the palm rest.



8. Loosen in consecutive order the four captive screws, labeled "1" through "4," that secure the microprocessor thermal-cooling assembly to the system

board.



9. Lift up the microprocessor thermal-cooling assembly and remove it from the system board.

Replacing the Microprocessor Thermal-Cooling Assembly



1. Evenly apply thermal grease to the top surface of the microprocessor.



2. Place the microprocessor thermal-cooling assembly over the microprocessor.



3. Tighten the four captive screws, labeled "1" through "4," in consecutive order.

CAUTION: Before you perform the following procedures, see the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

microprocessor thermal-cooling assembly

captive screws (4)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45

Commentaires sur ces manuels

Pas de commentaire

Dell Inspiron 6000 Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Carnets de notes Dell Inspiron 6000