Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 112)

Chapter 5 Configuring Your Library

Working With FC I/O Blades

Dell PowerVault ML6000 User’s Guide 112

Details on configuring channel zoning include:

• By default, all target FC ports (ports 1 and 2) on an FC I/O blade have

access to all initiator ports (ports 3–6).

• Changing channel zoning setting will cause the affected FC I/O blade

to reboot.

• If host port failover is enabled on the FC I/O blade, channel zoning

must be configured so that all target FC ports have access to all

initiator ports. For information on host port failover, see Configuring

FC Host Port Failover on page 119.

• The Setup - FC I/O Blade Channel Zoning screen on the Web client lists

all FC I/O blades found in the library. FC I/O blades are listed by the

following: location in the library, WWNN, and status. The

corresponding Channel Zoning Select Blade screen on the operator

panel lists the location in the library and state. You can select the FC

I/O blade you want to configure for channel zoning and proceed to

the next screen.

• The two FC target ports (ports 1 and 2) and the four FC initiator ports

(ports 3–6) are displayed in a grid, with the target ports listed in

columns and the initiator ports listed in rows. Check boxes allow you

to associate a target port with an initiator port.

• To permit access, select the check box at the intersection of the

target port and the initiator port. You can associate each initiator

port with more than one target port.

• To restrict access, clear the check box at the intersection of the

target port and the initiator port.

• When you select a check box, the entire FC channel is zoned. This

zoning affects any host application that might be accessing the

FC I/O blade. If both channel zoning and host mapping are

enabled, the channel zoning settings supersede any host LUN

mapping on the FC I/O blade.

• After configuring channel zoning, save the library configuration.

For instructions on how to save the library configuration, see

Saving and Restoring the Library Configuration on page 384.

Note: If both channel zoning and host mapping are enabled, the

channel zoning settings supersede any host LUN mapping on

the FC I/O blade.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 112