Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 283)

Chapter 12 Installing, Removing, and Replacing

Preparing to Remove or Replace a Module

Dell PowerVault ML6000 User’s Guide 283

Library Expansion Module. Library_a and Library_b still require

partition modifications to remove the drive reference and hereby free

the 9U Library Expansion Module of all partition resource references.

9 If you are removing or replacing a 9U Library Expansion Module, set

the number of I/E station slots to six. You can reconfigure I/E station

slots after the module removal or replacement is complete. See

Configuring I/E Station Slots on page 81.

10 Power off the library.

11 Disconnect all power cords, network data cables, and module-to-

module cables from each module you will be removing.

12 Park the robot assembly in the 5U Library Control Module. Before

unstacking the library, the robot assembly must be placed in the 5U

Library Control Module.

a Open the I/E station and access doors of each module.

b Using your hands, gently lift the robot assembly into the 5U

Library Control Module. The robot assembly should glide slowly

and with some resistance.

c After raising the robot assembly to the approximate middle of the

5U Library Control Module, hold it in place with one hand and,

using your other hand, move the parking tab in a counter-

clockwise direction until it stops in the “parked” position. The

metal parking tab is located at the bottom of column 1.

d Gently lower the robot assembly to rest on the parking tab.

Note: You should label all cables before you remove them so you

can later reconnect them to their proper locations.

Caution: Support the robot assembly by holding onto the

broad metal X-axis plate. Lifting the robot by the

thin metal rod will bend the rod. Lifting the robot

by the black plastic picker body can damage the

robot.

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 283