Dell PowerVault ML6000 Manuel d'utilisateur Page 321

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 438
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 320
Chapter 12 Installing, Removing, and Replacing
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
Dell PowerVault ML6000 User’s Guide 321
Equipment Required
12
Ethernet Cable.
Host PC or laptop connected to the Dell PowerVault ML6000 library.
Current Dell PowerVault ML6000 library firmware file saved to your
host PC or laptop. Firmware downloads are available at
http://support.dell.com.
Latest library configuration saved on PC or laptop.
Instructions 12
The Compact Flash Card is new and has never been initialized. It contains
only a minimal level of library firmware which allows the library to boot
up and display an Upgrade Notification message. Once you install the
LCB/compact flash card, you will need to upgrade firmware and
reconfigure your network settings.
1 If possible, save the library configuration (see Saving the Library
Configuration on page 385).
2 Power off the library.
3 Disconnect all cables from the existing LCB. You may want to label
each cable that is connected to the existing LCB to make sure that you
can correctly reconnect them to the new LCB.
4 Remove the existing LCB from the library.
To remove the existing LCB, release both of the LCB latch hooks and,
using the latch hooks as handles, pull the entire LCB toward you.
Note: Do not separate the old compact flash card from the library
control blade.
Vue de la page 320
1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 437 438

Commentaires sur ces manuels

Pas de commentaire