Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 303)

100

101

Chapter 12 Installing, Removing, and Replacing

Replacing the 5U Library Control Module

Dell PowerVault ML6000 User’s Guide 303

Place the 5U Library Control Module on top of the 9U Library

Expansion Module and slide it to the rear of the unit. A small notch

on the bottom of the 5U Library Control Module aligns it with the top

of the 9U Expansion Module.

6 Use rack ears to fasten the 5U Library Control Module on top of a 9U

Expansion Module.

7 If you placed the 5U Library Control Module on top of a 9U Library

Expansion Module, secure the two modules by tightening the two

thumbscrews at the base of the front of the module and the two

thumbscrews located at the base of the back of the module. Then

lower the module’s guide pin (located at the base of the front of the

module) by turning it and pushing it down.

8 Stack all 9U Library Expansion Modules (if any) in their original

positions above the 5U Library Control Module. Use rack ears to

fasten the modules to the rack.Then tighten all thumbscrews located

at the base of the front and back of the modules.

9 Engage the Y-rails. Tighten the thumbscrews and lower the guide

pin. Doing this aligns the Y-rail with the Y-rail of the module beneath

it.

a From the front of the library, open the I/E station and access

doors of the 5U Library Control Module. Squeeze the handle of

the Y-rail release mechanism, lift it out of its locked position, and

slide it downward as far as it will go.

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 437 438

Commentaires sur ces manuels

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 303

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Dell PowerVault ML6000